PLANT!T Aqua Garden Instructions page 2

GB
Thank you for purchasing your new Aqua Garden by PLANT!T
You can grow a variety of plants in your Aqua Garden by PLANT!T. Thanks to the
hydroponic growing method and oxygen-rich nutrient solution, your plants will
grow quicker and stay healthier for longer.
The Aqua Garden by PLANT!T circulates water from inside the tank to the each plant
site. After watering the plant site, water runs back into each pot at regular intervals,
bringing oxygen-rich nutrient solution to the roots and back into the tank.
Simply fill your reservoir tank with water and plant nutrient (supplied), add your
seeds and watch them grow.
Assembly instructions
Rinse the Aqua Garden by PLANT!T thoroughly with water before use.
1. Firstly, place all components on a flat surface.
2. Turn the tank over so the base of the tank is visible. Pick
up the water level indicator and push that into the inlet.
4. Now disassemble the support
column by turning the top half of
the column 45° clockwise.
45°
5. Place the top and base of the
support column on a flat surface.
3. Push the indicator
into the indent
running down the
side of the tank
making sure it is
securely fastened.
Ensure the indicator
is pushed up as far as
it will go.
What is in the kit:
Lid
Cover
Support column
Pump
Pump pipe (12 cm)
Tank
Visual water level
indicator (20 cm)
Pots
Multi regional power plug
(including USB cable)
ROOT!T Rooting Sponges
ROOT!T First Feed
6. Connect the pipe
to the upper part
of the support
column. Then
connect the other
side of the pipe to
the pump outlet.
7. Position the top and
base part of the support
column on top of one
another, then turn them
45°
45° anticlockwise. Push
the pump gently from the
top with a finger to attach
the suction cups on the
pump to the base of the
support column.