temperature of the water around 8
temperature, making the wind cooler.
Operation Method
1) Put the ICEBOXES into the refrigerator and keep them
inside till they are completely frozen.
2) Put them into the water tank from the Adding water cover on the
left of the unit. And then close the door. The temperature of the
0
water will be 8
C lower than that of the ambient temperature and
keeps for 4 hours, cooling the wind.
3) Using the two ICEBOXES alternately allows continuous cooling.
Points for Attention
l When adding water, do not exceed the "MAXIMUM" level.
l Choose normal wind when environmental humidity is too
high as cooling function is accompanied with humidifying.
l After adding water, do not tilt the unit or crash into objects
when moving the unit, this keeps water from overflowing
from the water tank.
l Do not put any objects on the unit.
l Disconnect power and pull out the plug before cleaning.
l Clean the cabinet of the unit with a damp cloth and mild
detergent. Do not use aggressive detergents or solvents to
clean the cabinet. Do not pour water on the control panel.
All manuals and user guides at all-guides.com
0
C lower than that of the ambient
-13-
l If the machine has fallen down with water in it, the plug
should be pulled out of the outlet immediately. The machine
can be switched on after 24 hours. You might damage the
machine if you do not follow this instruction.
l Do not place the Air outlet or Air inlet of the unit close to a
wall or curtain, otherwise air can be blocked which will
effect performance.
l You will hear some uneven wind noise after using for a long
period of time. This is because the air filter is dusty and
blocks the airflow. Clean the filters (see the section on
cleaning the filters).
l When not using the appliance, pull the plug out of the wall
outlet.
l The appliance must be taken to a qualified service agent for
repair.
l If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid an electrical hazard.
NOTE:
Do not let water come into contact with the control Panel as high
voltage is present inside the unit, unplug the unit when cleaning
or filling / draining water.
-14-