Publicité
Les langues disponibles
Les langues disponibles
POSITIONING THE TEMPERATURE TRANSMITTER:
The Transmitter is supplied with a holder that may be
attached to a wall with the two screws supplied. The
Transmitter can also be position on a flat surface by
securing the stand to the bottom of the Transmitter.
To wall mount:
1. Secure the bracket onto a desired wall using
the screws and plastic anchors.
2. Clip the remote temperature sensor onto
the bracket.
Note:
Before permanently fixing the transmitter wall base,
place all units in the desired locations to check that
the
outdoor temperature reading is receivable. In event that the signal is
not received, relocate the transmitters or move them slightly as this may
help the signal reception.
CARE AND MAINTENANCE:
Extreme temperatures, vibration and shock should be avoided as
•
these may cause damage to the unit and give inaccurate
forecasts and readings.
Precautions shall be taken when handling the batteries. Injuries,
•
burns, or property damage may be resulted if the batteries are in
contact with conducting materials, heat, corrosive materials or
explosives. The batteries shall be taken out from the unit before
the product is to be stored for a long period of time.
Immediately remove all low powered batteries to avoid leakage
•
and damage. Replace only with new batteries of the
recommended
type.
37
Publicité
