Technoline WS 9136-IT Livret D'instructions page 32

To set the clock:
1. The hour digits start flashing in the time display section.
2. Use the + key to adjust the hours and then press SET key to go to
the minute setting.
3. The minute will be flashing. Press the + key to just the minutes.
4. Confirm with the SET key and exit the setting mode.
Note:
The unit will still try to receive the signal despite a manual setting. When
the signal is received, the manually set time will automatically be
replaced by the received time. During reception attempts, the DCF
tower
icon will flash. If reception has been unsuccessful, the DCF tower icon
will not appear but reception will still be attempted.
ALARM SETTING
Alarm icon (ON)
To set alarm:
1. Press and hold ALARM for about 3 seconds until the alarm time
display flashes.
2. The hour digit and the alarm icon will be flashing. Press the + key
to adjust the hour.
3. Press ALARM button once and minute digit will be flashing. User
shall then press + button to set the minute.
4. Press ALARM button once to confirm the setting.
5. To activate/ deactivate the alarm function, press the ALARM
button once. The display of the alarm icon represents that
the alarm is "ON".
Note: The duration of alarm sounding is 85 seconds
Alarm time
31