Hendi 230268 Manuel De L'utilisateur page 5

Intended use
• This appliance is intended for washing crockery,
such as glasses, cups, plates and cutlery. Any
other use may lead to damage of the appliance
or personal injury.
Grounding installation
This appliance is classified as protection class I
and must be connected to a protective ground.
Grounding reduces the risk of electric shock by
providing an escape wire for the electric current.
Preparation before first use
• Open the package. Before setting up the appli-
ance, check it for any externally visible damage
due to transportation. If in any doubt, call for a
specialist to check it (from the authorized local
dealer who sold the appliance).
• Place the dishwasher at the installation area,
close to the necessary water and power supply
(the ground should be sufficiently stable).
• Remove the protective foil protecting the steel
housing of the dishwasher from scratches. Any
remaining adhesive residue should be careful-
Connection to the water supply
ATTENTION: The connection with the water sup-
ply should be made according to the current safety
standards.
The dishwasher may be connected to water sup-
ply with maximum inlet temperature 60°C/130°F.
In case you need connection with water supply of
high temperature please contact our Factory or our
distributor or our local dealer.
• The water supply hose should have a flap valve
(non-return valve) according to DIN 1988.
• The water supply hose/pipe should be rinsed be-
Drainage connection
• The outflow is accomplished through gravity
force (natural flow). The outlet hose should be
connected either directly to the main drainage -
where a pipette for odours is anticipated, or wa-
ter runs directly to a drainage well in the ground,
• Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.
This appliance is fitted with a power cord that has a
grounding wire and grounded plug. The plug must
be plugged into an outlet that is properly installed
and grounded.
ly removed. Do not use any scouring materials.
Leaving the protective foil can cause difficult to
remove adhesive glue foil to the dishwasher's
steel housing.
• The appliance should be placed horizontally.
Possible inclinations should be corrected using
a spirit level.
• Following the successful installation, the dish-
washer should be cleaned thoroughly with a con-
ventional detergent before it is put into operation.
fore the appliance's connection.
• The water supply hose/pipe should have a min-
imum internal diameter of 16 mm and the con-
nection with the hose should be 3/4 inch.
• All hose collars should be adjusted in a fixed po-
sition before the appliance is put into operation.
• The dishwasher can be only connected to a
well-functioning softener.
ATTENTION: The water pressure must be between
2 and 5 bar.
which has a pipette for odours.
ATTENTION: The outlet hose should not be placed
higher than a level of 650mm from the lower side of
the dishwasher's dispenser.
EN
5