Hendi 230268 Manuel De L'utilisateur page 10

ing cycle, the machine receives detergent for 13
sec and rinse aid for 12 sec. This could be adjusted
from the user through the User Menu *Check Sec-
tion "User Menu".
NOTE: In case that you need to adjust the Deter-
gent or Rinse Aid from the User Menu, please bear
in mind that for each second the corresponding
pump captures the following liquid quantities:
Cold Water Rinse
This machine has Cold Water Rinse operation. It
could be activated in order to be performed after
every washing cycle or for On Demand occasions.
In order to perform a Cold Water Rinse after one
washing cycle, press Button SW5 for 1 sec. A single
sound buzz will inform you that the machine is set
up for a single cold rinse performance. Then, LED
L5 will be on, while the procedure is performed.
Shutting down the machine
EN
ECO Function
In case that the machine is in Standby operation
for more than 15 minutes, the Boiler's temperature
lowers in order to avoid unnecessary power con-
Soft Start Function
This machine is equipped with Soft Start System
that enables the water pump to start with lower
User's Menu
In order to enter the User's Menu, shut down the
machine and press hold Buttons SW1, SW3 & SW6
at the same time for 3 sec with the door closed.
LED L6 flashes and a beeper sounds three times.
Message "conf" apears for a few seconds and the
User's Menu is activated.
10
• Detergent pump: 0.83 ml/sec
• Rinse Aid pump: 0.19 ml/sec
By multiplying these quantities with the time dura-
tion (seconds) that the pump works, you can calcu-
late the volume of each liquid that it is used.
WARNING: The machine receives rinse aid during
washing cycle and detergent during rinsing cycle.
In case that you wish to perform Cold Water Rinse
after each washing cycle, press hold But-ton SW5
for 5 sec while the machine is on Standby mode. A
double sound buzz will inform you that the machine
is set up for a cold rinse performance after every
washing cycle (LED L5 will lit). Should you undo the
selection, please repeat the above procedure.
In case that you want to shut down the machine, re-
move the overflow hose in the wash tank and press
the Button SW4. The machine is going to drain au-
tomatically the used water, perform a self-cleaning
cycle and then shut down. An alternative way is to
press continuously the Button SW6 until the indi-
cation "OFF" appears in the first line of the screen
(it will take about 5 sec). The recommended way is
the first.
sumption. During these intervals, if the door of the
washing machine opens, the ECO Function stops.
pressure and gradually increases it, so that the
sensitive crystals are not damaged.
Find the parameter that you wish to adjust using
Buttons SW3 and SW4 for navigation inside the
menu. The corresponding parameter will be dis-
played on the screen.
Should you wish to increase the amount (+), press
Button SW1.