Publicité
Les langues disponibles
Les langues disponibles
Please note: If the density of the sample intended for centrifugation exceeds 1.2 g/ml,
the maximum speed value should be recalculated acc. to the formula below:
Where,
N - new maximum rotation speed
n- original maximum rotation speed
S- density of the tested sample
•
Press and hold the (4) button on the control panel until "04:39" flashes on the display.
Then, use the "Up" (5)/"Down" (6) buttons to set the preferred time value for the
device operation.
•
Press and hold the (4) button on the control panel until "2" flashes on the display.
Then use the "Up" (5)/"Down" (6) buttons to set the preferred value.
Please note: The device is factory set to "b5". There is no need for the user to set
this parameter themselves.
6. To start the process, press the START button (2), and the power LED (7) lights
up green. The display will show the current speed value (the set value will be
reached in about 1-2 minutes), and the countdown time to the end of
spinning.
7. To stop the device, press the STOP (9) button or wait until the timer counts
down to the value 0. The LED (8) will turn red. The device will not be fully
stopped until the actual speed value is 0 on the display.
8. Remove the test tubes with centrifuged samples.
Time setting
Acceleration and deceleration values setting
���� = ���� � 1.2 ∕ ����
Publicité
