Installing The Faucet - Transform QL036 Manuel De L'utilisateur

Installation (continued)

INSTALLING THE FAUCET

- Remove the retaining nut, metal washer, and rubber gasket
from the mounting shank of the faucet .
- Insert the faucet hose and the mounting shank through the
faucet hole in the sink and rest the faucet on the sink .
- Install the rubber gasket, metal washer, and retaining nut onto
the mounting shank to secure the faucet to the sink . Hand
tighten the retaining nut until it is snug . Tighten the screws of
the retaining nut using a screw driver . Do not overtighten .
- Attach and hand tighten the main water supply outlet to the
sprayer hose . Use two wrenches to tighten the two ends
together. Please note, tightening the fittings with a single
wrench may damage the faucet and void the warranty .
- Fully retract the sprayer hose . Install the counterweight about
2 in . (50 mm) from the bottom on the side closest to the
sprayer head .
- Attach and hand tighten the supply lines (not supplied) onto
the faucet inlet fittings. Use two wrenches to tighten the two
ends together. Please note, tightening the fittings with a single
wrench may damage the faucet and void the warranty .
NOTE:
It is helpful to have a second person hold the faucet in place while
tightening the mounting nuts. Please ensure that none of the supply lines
are kinked during installation.
QL036
Faucet body
Spray Hose
Hot / Cold
Supply Lines
Rubber
Gasket
Retaining Nut
Counterweight
2 in . (50mm)
Main Water
Supply Outlet
Spray Hose
8
Spray
Faucet
Head
Spray Head
Fitting
Mounting
Shank
Main Water
Supply Outlet
Supply Line
Inlet Fittings
Sink
Metal
Washer
Screws
Sprayer Hose