Installation; Faucet Assembly/Installation - Transform QL029 Manuel De L'utilisateur

Installation

FAUCET ASSEMBLY/INSTALLATION

1 . Hold the end of the hose with large fitting with one hand and, with
the other hand, hand tighten the spray faucet head clockwise onto
the large fitting. Push the hose in so that the head aligns properly
with the notches on the faucet pipe .
2 . Unscrew the retaining ring from the bottom of the faucet body,
ensuring that the washer and gasket are removed with the
retaining ring .
3 . Install the faucet through the hole in the sink, by first threading the
hose through the hole, then placing the base of the faucet through
the hole . A second person may be required to hold this in place
until the faucet installation is complete .
4 . From underneath, slide the washer and gasket, then the retaining
ring, over the free end of the hose . Slide them up to the exposed
threaded section of the faucet .
5 . Tighten the retaining ring by hand until it is snug . Using a wrench
or pliers, tighten the assembly . Gently tighten the two screws on
the retaining ring . Do not over tighten .
6 . Attach the end of the hose with the small fitting onto the faucet
outlet and hand tighten . Then, using one wrench on the hexagonal
nut of the faucet outlet and another on the hose nut, tighten the
two ends together . Tightening with just a single wrench may
deform the hose nut .
7 . Install the counterweight on the hose about 457 mm (18 in .) from
the underside of the faucet . This can beadjusted based on your
own requirements, but this is the normal location .
QL029
All manuals and user guides at all-guides.com
6 6
Faucet body
Gasket
Retaining ring
457 mm
(18 in.)
Counterweight
Faucet outlet
Faucet
pipe
Large
fitting
Spray
faucet
head
Washer
Screws
Faucet
outlet
Small fitting
Hose
Small
fitting
Hose