Mounting The Utility Sink; Drainage; Supply Lines; Maintenance - Transform QL036 Manuel De L'utilisateur

Évier utilitaire, armoire de rangement et robinet
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation (continued)

MOUNTING THE UTILITY SINK

Position the cabinet in the intended location . If required, level the cabinet by adjusting
the four leveling legs and checking the alignment of the top using a carpenter's level .
Carefully place a bead of sealant all around the top of the cabinet .
Ease the sink onto the cabinet, and ensure it is placed evenly and centered on the
cabinet . Wipe off any excess sealant . Use masking tape to hold the sink in place until
the sealant dries .

DRAINAGE

The tailpipe (not supplied) previously installed to the drain can now be connected
to your household plumbing . In some cases, your household plumbing will have to
be modified to ensure proper drainage. If so, please consult a licensed plumber to
complete needed modifications.

SUPPLY LINES

Connect the supply lines to your home's water supply as per manufacturer's instructions .
Open the hot and cold water supply valves and check to make sure they have
been installed to appropriate inlet ports . Check for leaks . Run hot and cold water
uninterrupted for about one minute to remove any residue from the lines .

Maintenance

CARTRIDGE REPLACEMENT

-
Turn off the water supply to the faucet .
-
Remove the setscrew cap . Loosen the setscrew with the hex
key provided and remove the handle .
-
Gently unscrew the decorative cap by hand . Use a wrench to
unscrew the retaining nut .
-
Pull the cartridge out of the faucet body and replace it with a
new ceramic cartridge . Ensure new cartridge is seated properly
with the locating pins in appropriate place .
-
Secure the cartridge in place using the retaining nut .
-
Gently tighten the retaining nut using a wrench . Do not
overtighten .
-
Reinstall the decorative cap . Reset the handle and make sure
it rotates freely . Replace the setscrew and cover it with the
setscrew cap .
-
Turn the water supply to the faucet back on .
-
Operate the faucet to make sure everything works correctly
QL036
Setscrew
Setscrew Cap
Decorative Cap
Retaining Nut
Cartridge
Faucet body
10
Handle

Publicité

Chapitres

Table des Matières
loading

Table des Matières