Cornelius SOLANO Instructions D'assemblage page 9

25x38-Trevi Solano RONDE_ Page 9
9
BACK CAP
UPRIGHT
10
Place the top seat on the upper side of the upright.
Align the holes on top seat with the right pool size on the
top plate.
Secure the top seat with two (4) screws.
11
Starting inside the pool, slide the seat cap on
the post until it hooks on the edge of
the ledge.
12
Position the safety procedures panel on the outside of the
pool. This panel must be at the most visible place from the
yard on your pool.
13
Note: See 'Safety Information" Manual, Page 1.
As described in the manual, all components of the
filtration system should be placed to prevent a child to
climb on top and get access to the pool.
Using a little bit of stone dust (or sand), place at level a
patio stone 61cm x 76 cm (24" x 30") before installing the
motor and filter.
Position the motor on the stone and insert the two nozzles
to connect the hoses.
Then, install the filter tank. Adjust the lateral assembly
properly in its channel. It is sometimes necessary to
install the laterals.
Patch the center hole of the lateral assembly using the
plug to allow filtering sand to flow into the tank.
Remove the plug. Install the joint in the cavity and secure
the filter head by placing the back wash position on
opposite side of the pool.
Install necessary nozzles, then connect hoses using
collars.
1. The first hose runs from the top of the pump to the side
of the filter head;
2. The second one goes from the pump to the skimmer
(or to the bottom drain valve);
3. The third goes from the front of the filter head to the
water return or from the front of the chlorinator to the
water return.
A back wash hose may be placed behind the filter head.
If there is a chlorinator and/or heat pump, it must be
assembled at the filter exit.
BACK CAP INSTALLATION
SIDE VIEW
TOP SEAT INSTALLATION
SEAT COVER INSTALLATION
SECURITY SIGNS INSTALLATION
FILTRATION SYSTEM ASSEMBLY
First clip the top of the back cap
on the nose of the upright.
Then clip the bottom hook
of the back cap.
SEAT CAP
Place the three (3) safety stickers inside the pool in a way
that it's seen from any entry point of the swimmer (See
positionning drawing).
SCREW
TOP SEAT
UPRIGHT
UPRIGHT