VQ OrthoCare BioniCare Hand System Manuel D'utilisation page 11

Applying the Generator Dock and Glove:
Pull the glove on the hand, making sure that your fingertips reach the ends
of the glove. Place the generator dock over the glove lining up the two
velcro dots with the strips of loop on the glove. Make sure that the straight
edge of the device is towards the hand and the curved edge is towards
your elbow. Attach the strap, placing the connector into the keyhole and
pulling down to secure. Adjust the elastic strap as needed to fit snugly on
your wrist.
Connecting the Device:
Slide the device into the generator dock as shown below. Press the device
in place, making sure that you hear a click that will secure it in place.
Starting Your Treatment
Check that the components are in place and all connections and adjustments
are correct.
1. Turn the Signal Generator on by pressing the Select/Power button until
BioniCare appears on the screen. The screen will then advance to the
main treatment menu.
2. Press the
3. Increase the signal level by pressing the Increase Button
touch screen or the corresponding manual button. Increase the voltage
until you feel a tingling sensation in the hand or wrist.
4. Press the Decrease Button
manual button a few times to reduce the stimulation level just enough
so you no longer feel the tingling sensation. You have now begun
your treatment.
Note: If the Signal Generator voltage is set below 2.0 V, the device will begin to
beep after 5 minutes and will turn off after 10 minutes.
play button.
on the touch screen or the corresponding
on the
ENGLISH | 9