Publicité
Les langues disponibles
Les langues disponibles
EN
The SA-100 is a smoke detector set for
discovery of fire in the first stage. If smoke
develops, the SA-100 will give a loud beep of at least
85dB (A). As part of the link function all the smoke
alarms within range will sound the alarm. We advice
to test the smoke detectors weekly using the test
button on the detectors. Save this manual in a safe
place or inside of the electricity meter cupboard.
RECOMMENDED INSTALLATION LOCATIONS
FOR THE SA-100:
•
Install the first smoke detector near the bedroom.
Ensure that it is placed so, if it would detect fire, at
least one exit route would still be accessible. We
recommend to place one alarm near each poten-
tial blockade of your exit route, so you are alerted
before a fire would block off escape.
•
Use multiple detectors to increase safety and ensure
alert before the escape route is blocked.
•
Install at least one smoke detector on each floor
of your house.
•
Install at least one smoke detector in each room
where people smoke or where there is equipment
that may potentially cause a fire.
•
Smoke and heat will first move upwards towards
the ceiling; after that the smoke and heat will
travel horizontally.
•
Install the detector on the ceiling. Except for rooms
smaller than 1m, you should stay at least 50 cm
away from the wall and 61cm from any corner.
Smoke and heat do not gather in such corners,
preventing the detector from alerting you on time.
Publicité
