Accessories; Application Method - PULOX PO-650B Mode D'emploi

E. Replace the cover.
F. Insert the SpO
(The probe is limited to be produced by our company; never
replace it with the similar one by other manufacturers).
Please take care when you insert the batteries, for the
improper insertion may damage the device.
If the alarm function is on, the device will provide high
priority alarm signal when the battery is in low power status.
Intermittent alarm will occur and the battery icon turns red
in the state of flashing.
High priority indicating that immediate operator response is
required.

5.4 Accessories

User Manual, 2AA battery (optional), data line, Oximeter probe infant
(optional)
6. Operating guide

6.1 Application Method

A
a. Insert the suitable probe into the jack on the right side of the
device (The probe is limited to the one that is provided by our
company; and can't be replaced with the similar one by other
manufacturers).
b. Put the finger into the probe as Figure 5.
c. Long press power button until the device is turned on.
d. Do not shake the finger and keep the patient in a stable state
during the process.
e. The data can be read directly from the screen in the measure
interface.
Fingernails and the luminescent tube should be at the same
side.
Figure 4 Batteries Installation
probe of the pulse oximeter in the upper jack.
2
EN