PULOX PO-650B Mode D'emploi page 105

Appendix 1
State
Low voltage alarm
SpO alarm
2
Pulse rate alarm
Probe error alarm
Appendix 2
Guidance and manufacture's declaration
Guidance and manufacture's declaration – electromagnetic
emissions- for all EQUIPMENT and SYSTEMS
Guidance and manufacture's declaration – electromagnetic emission
The CMS60D Pulse Oximeter is intended for use in the
electromagnetic environment specified below. The customer of the
user of the CMS60D Pulse Oximeter should assure that it is used in
such and environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic
emissions
IEC 61000-3-
2
Voltage
fluctuations/
flicker
emissions
Alarm condition
delay
1s
330ms
330ms
16ms
Compliance
Group 1
Class B
Not
applicable
Not
applicable
Alarm signal
generation delay
20ms
20ms
20ms
20ms
Electromagnetic environment
– guidance
The CMS60D Pulse Oximeter
uses RF energy only for its
internal function. Therefore,
its RF emissions are very low
and are not likely to cause any
interference in nearby
electronic equipment.
The CMS60D Pulse Oximeter is
suitable for use in all
establishments, including
domestic establishments and
those directly connected to
the public low-voltage power
supply network that supplies
buildings used for domestic
purposes.