Operation - onsen 3.0 Guide D'utilisation

OPERATION

NOTE: This pump is designed for intermittent duty only. Continuous
duty usage will shorten the life of the pump and is not covered under
the warranty.
1
Make sure the pump is installed properly according to the installation
instructions above (wait before powering the pump).
2
Make sure the battery being used to power the pump is fully charged.
3
Open the water source (showerhead, faucets, etc.) connected to the pump.
4
Switch ON power to the pump. Water will begin to flow and fill the
water lines connected to a water heater, toilet, shower, etc. The goal
is to remove the air from the plumbing system and fill it with water.
5
Once the lines are completely filled with water, shut off all water fix-
tures (showerhead, faucets, etc.).
6
When all water fixtures are shut off, the pump will stop automatically
(if the pump fails to stop, switch OFF power to the pump and refer to
the Troubleshooting section of this Operating Manual).
7
The pressurized plumbing system is now ready for use. Open the water
fixture needed and the pump will automatically start pumping water to it.
CAUTION
onsenproducts.com
10
onsenproducts.ca
ALWAYS SWITCH OFF POWER TO THE PUMP WHEN
LEAVING IT UNATTENDED OR WHEN NOT IN USE.
800-996-5559 support@onsenproducts.com