Using The Radiator; Cleaning And Maintenance; Breakdowns And Solutions; Technical Data - Inventum KO931B Mode D'emploi

4

using the radiator

SWITCHING THE RADIATOR ON AND OFF
Insert the plug in the socket and turn the thermostat button to the maximum temperature . Turn the position button to
position I, II or III to switch on the radiator.
To heat a room quickly, it is recommended to use the highest position III. Once the room has reached the required temperature,
the radiator can be set to a lower position to reduce energy consumption and prevent the room from getting too hot.
Turn the position button to 0 to switch off the heater and remove the plug from the socket. It takes a while for the radiator to
cool down, because the oil in the radiator is hot.
The radiator has a thermostat to regulate temperature and keep a room at room temperature.
Turn the thermostat button to the maximum position
Once the required temperature is reached, slowly turn back the thermostat button towards the minimum position
you hear a click sound. The radiator switches off. The radiator will now switch on and off automatically to maintain the set
room temperature.
Overheating protection
When the radiator gets too hot due to ambient temperature or extended use, the radiator switches off automatically.
Allow the radiator to cool down before you switch it on again.
MOVING THE RADIATOR
Switch off the radiator, remove the plug from the socket and allow the radiator to cool down before moving it.
Carefully move the radiator so that the swivel castors are able to roll properly.
5

cleaning and maintenance

Before cleaning the radiator, switch it off and remove the plug from the socket. Always allow the radiator to cool down fully,
before cleaning or storing it. Regularly clean the radiator. At least once per seasonal use.
• Clean the outside of the appliance only by means of a lightly damp cloth.
• Do not use aggressive or abrasive cleaning agents for cleaning the appliance.
• Prevent scratches in the paint. This could cause rust.
• Never submerge the radiator in water or any other liquid.
• Store the radiator on a cool and dry location.
6

breakdowns and solutions

First check the following if your heater is not working.
• Check the fuses in the meter cupboard.
• Check that the plug is properly inserted in the socket and that the socket receives power.
• Keep the heater clean. Dust, dirt and/or contamination on the radiator are a common cause for overheating.
Make sure that such contamination is removed regularly.
• If the radiator suddenly stops during heating, it is possible that the overheat protection is switched on. Switch off the
radiator, remove the plug from the socket and allow the radiator to cool down. Switch on the heater according to the
instructions, after it has cooled down.
7

technical data

Type number KO931B
Voltage 220-240V, 50Hz
Power position I = 800 watts, position II = 1200 watts, position III = 2000 watts
14
• English
and turn the position button to position III to switch on the radiator.
until