Napoleon PF450 Manuel D'utilisation page 6

LIGHTING INSTRUCTIONS
Open lid.
Ensuring all burner controls are in
the off position, turn on the gas
supply valve.
Rear Infra-Red Burner
Lighting
Remove warming rack.
Turn rear burner valve
on, push in, and hold.
With valve held in,
push and hold left
igniter switch until rear
burner lights.
Keep valve depressed
for 10-15 seconds and
release.
If ignition is not
immediate, turn the
burner control off.
Wait 5 minutes.
Once burner is lit, allow
a 5 minute pre-heat
period before adjusting
to med or low.
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames will be achievable.
Do not use rear burner while operating any of the main burners.
LIGHTING PORT
HOLE
(BOTH SIDES)
PILOT
BURNER
INFRA-RED
BURNERS
Main Infra-Red
Burner Lighting
Turn pilot burner
control to high
Press and hold left
igniter switch until lit,
or light by match.
Once pilot is lit, turn
left and/or right infra-
red burners to high.
If ignition is not
immediate, turn
burner control off.
Wait 5 minutes.
Once infra-red burner
is lit, leave on high for
5 minute pre-heat
period before adjusting
to medium or low.
Keep pilot on while
operating infra-red
burners. Turn off
after use.
MAIN
MAIN
LEFT
TUBE
IGNITER
BURNERS
Main Tube Burner
Lighting
Turn left or right tube
burner control to high.
Press and hold left
igniter switch until lit,
or light by match.
If ignition is not
immediate, turn the
burner control off.
Wait 5 minutes.
With one tube burner
operating in the high
position, turn the
other tube burner
control to high.
REAR
INFRA-RED
BURNER
LIGHTS
FRONT REAR SIDE
RIGHT
SIDE BURNER
IGNITER
BURNER
Side Burner Lighting
Turn front or rear side
burner control to high.
Press and hold right
igniter switch until lit,
or light by match.
If ignition is not
immediate, turn the
burner control off.
Wait 5 minutes.