Troubleshooting - OXO BREW Mode D'emploi

Problem
Kettle is plugged in but will not turn on
Kettle is pouring too slowly
Kettle is taking longer than usual to boil
I selected 212°F but the Kettle always stops at 204°F
How do I change from F to C?
12

Troubleshooting

If Kettle is plugged in and turned on without any water in it, it will automatically shut off to
prevent overheating. The Kettle will be able to turn on again in a few minutes after it cools
Check the removable filter in the spout for clogging. If necessary, clean the filter with a
Your Kettle might need to be descaled. See page 10 for descaling instructions.
Check your altitude; your boiling point may be lower than 212°F. The Kettle cannot reach
To change temperature unit while in use, press OXO button for 3 seconds, twist dial to
choose between F and C, and press OXO button again to confirm. The display will show
For the most up-to-date troubleshooting information, visit oxo.com
Solution
back down to a safe temperature.
soft-bristled brush and rinse with warm water.
temperatures higher than your altitude's boiling point.
the temperature of the water as it is being heated.