en
10
Do not rivet or screw any name-plates
or signs onto the battery charger. If the
insulation is damaged, protection
against an electric shock will be
ineffective. Adhesive labels are
recommended.
Charge only intact original FEIN bat-
teries that are intended for your power
tool. When charging incor-rect,
damaged, repaired or recondi-tioned
batteries, imitations or other brands,
there is danger of fire and/or explosion.
Caution! Using the charger with Blue-
tooth ® may cause interference with
other devices and systems, aircraft and
medical devices (e.g., cardiac
pacemakers, hearing aids). Also, the
possibility of humans and animals in
direct vicinity being harmed cannot be
completely exempt. Do not use the
charger with Bluetooth ® near medical
devices, chemical plants, areas with
explosion hazards (e.g. petrol stations),
in blasting areas and in aircraft. Avoid
operation in direct vicinity of the body
over longer peri-ods.
The Bluetooth ® word mark and logos
are registered trademarks of the
Bluetooth SIG, Inc. The use of this word
mark and the logos by C. & E. Fein
GmbH is under license.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with ISED Canada's licence-exempt
RSS(s).
Operation is subject to the following
two conditions: (1) This device may not
cause interference and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must acceptany
interference received, including
interference that may cause undesired
operation.
Caution: The user is cautioned that
changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pur-suant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harm-ful interference
in a rezidential instal-lation. This
equipment generates uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interfer-ence will not occur in a
particular installation. If this equipment
does cause harmful interference to
radio or television reception, which can
be determined by turning the equip-
ment off and on, the user is encour-
aged to try to correct the interference
by one or more of the following
measures:
–Reorient or relocate the receiving
antenna.
–Increase the separation between the
equipment and receiver.
–Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
–Consult the dealer or an expe-
rienced radio/TV technician for help.