Publicité
Les langues disponibles
Les langues disponibles
Weight
Clamping nut
Collet diameter
Cutting bit shank diameter
Battery operating temperature
Battery charging starting temperature
Battery storage temperature
6 Operation
6.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1.1 Inserting the battery
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
6.1.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
6.1.2.1 Fitting an accessory tool
Risk of damage. The collet can break if tightened when no accessory tool is fitted.
▶ Never tighten the collet when no accessory tool is fitted.
1. Clean the connection end of the accessory tool.
2. Check that the collet has been fitted.
3. Press the spindle lockbutton and hold it in this position.
4. Insert the accessory tool in the collet and tighten the clamping nut with the hex. wrench.
5. Release the spindle lockbutton.
6. Check that the accessory tool is held securely.
6.1.3 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Press the spindle lockbutton and hold it in this position.
2. Use the hex. wrench to release the clamping nut.
◁ The collet is slack.
3. Remove the accessory tool.
6
English
Printed: 30.11.2017 | Doc-Nr: PUB / 5311199 / 000 / 02
2
3
4
SCO 6-A22
3.1 lb
(1.4 kg)
/
" external hexagon
5
8
1/8", 5/32", 1/4"
1/8", 5/32", 1/4"
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
Publicité
