Changing The Engine Oil - Dulevo SPARK 1000 BH Mode D'emploi Et D'entretien

English
Charging procedure
Connect the battery charger connector to the battery wiring connector.
In the case of gel batteries, use a charger specific for gel batteries only.
Charge the batteries as instructed in the battery charger manual.

Changing the engine oil

On YH machines, change the engine oil when the "CHANGE ENGINE OIL" warning appears
on the display. On BH machines, change the engine oil at the intervals specified in the opera-
tion and maintenance manual provided by the engine manufacturer on the basis of the hour
counter on the machine's dashboard. Always change engine oil with the machine switched
Check that all machine functions are disabled, then lift the top cowling. Check that the engine is not
hot enough to cause burns then proceed as follows.
► Find the engine oil drain pipe and pass it through the hole in the engine compartment bot-
tom plate.
► Remove the oil level dipstick to facilitate drainage of the old oil.
► Position a suitable container under the drain pipe and unscrew the plug to let the old oil out.
► When the old oil has all drained out, fit the plug back in the drain pipe and arrange the
pipe back inside the engine compartment, making sure that it does not interfere with any
moving parts.
► Add new oil through the dipstick hole in the quantity specified in the engine's own manual.
► Once the right quantity of new oil has been added, fit the oil level dipstick and check that
the level is correct.
► Close the top cowling.
EN-40
! WARNING!
! WARNING!
Disconnect the connectors at the end of charging.
! WARNING!
off and the engine cold.
2014-07
1000 BH - 1000 EH - 1000 YH