Emptying The Top Unloading Debris Bin; Finishing Work; Moving The Machine When Not In Operation - Dulevo SPARK 1000 BH Mode D'emploi Et D'entretien

1000 BH - 1000 EH - 1000 YH

Emptying the top unloading debris bin

When emptying the bin, always wear a mask to protect the respiratory tract from the dust
Before emptying the debris bin, operate the filter shaker for 30 seconds to clean the filter
When you open the bin, all functions are disabled on EH and YH versions, and the engine is
► Press and hold the bin movement enabling button (1, fig. 29) then operate the bin up/down
switch (2, fig. 29) to raise the bin to the required height.
► Pull the lever (fig. 7) to rotate the bin and empty its contents.
► Turn the bin back to its horizontal position.
► Press and hold the bin movement enabling button (1, fig. 29) then operate the bin up/down
switch (2, fig. 29) to lower the bin again.
7

Finishing work

When you finish work, switch the machine off at the main switch, lift the side brushes and main
brush and engage the parking brake.

Moving the machine when not in operation

Proceed as follows to move the machine.
► Raise the side brushes.
► Raise the main brush.
► Select the direction of travel.
► Press the accelerator pedal.
! WARNING!
which is always present during this operation.
! WARNING!
! IMPORTANT!
also switched off on the YH version.
! IMPORTANT!
Shake the filter at the end of every work session.
29
2014-07
English
2
1
EN-31