Echo MTA-DTB Manuel D'utilisation page 20

Maintenance and care
1. Wear Indicators
Troubleshooting table
 For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.
Trouble
Line won't feed
Line fails to cut off
 Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
 Please contact your dealer in order to dispose of the product or its parts in compliance with national laws.
Storage
Storage hook installation
Manufacturer:
YAMABIKO CORPORATION
1-7-2 Suehirocho, Ohme, Tokyo 198-8760 JAPAN
Authorized Representative in Europe:
CERTIFICATION EXPERTS B.V.
Amerlandseweg 7, 3621 ZC Breukelen, The Netherlands
IMPORTANT
When the wear indicators located at the bottom of the nylon
line cutting head are worn smooth, replacement of the cover or
the entire nylon line cutting head is required.
IMPORTANT
Cause
1. Not enough line on the spool
2. Line tangled in the spool
1. Cut off knife in the shield is damaged
or missing
1. Insert small end of hook into locating hole on attachment
shaft.
2. Slide plastic cap onto end of attachment shaft.
18
Remedy
1. Rewind with new line
2. Unwind and rewind the line
1. Consult your dealer