Assembly; Fitting The Handle; Adjusting The Harness; Fitting The Impact Guard - Husqvarna 325HE3 Manuel D'utilisation

Fitting the handle

Fit the handle using two screws.

Adjusting the harness

(325HE4)
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back.
1 Put on the harness.
2 Hook the machine onto the harness support hook.
3 Adjust the length of the harness so that the support
hook is roughly level with your right hip.
10 – English

ASSEMBLY

Fitting the impact guard

(325HE4)
Fit the guard with three screws. Tighten the screws to 4
Nm. After the machine has been in use for around 20
hours, re-tighten the screws to 4 Nm.
1157424-49 Rev.1 2015-05-22