Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MOUNTING
Do not connect the machine
to the mains socket before it
is completely assembled.
MOUNTING THE GUARD
_
Place the guard on the appliance as
shown.
_
Fit the guard using the screws .
MOUNTING WHEEL ASSEMBLY
_
Adjust the location of the safety guard and the
wheel assembly.
_
Be sure that the pillar of the safety guard can
insert the hole of the wheel assembly.
_
Then fix them firmly with 2 screws by the driver.
REPLACING A SPOOL OF CUTTING LINE
_
Keep the release buttons depressed
and remove the lid from the housing.
_
Remove the spool from the housing.
_
Clean the housing.
_
Unwind the cutting line on the new
spool approx. 15 cm at both ends.
_
Feed the ends of the cutting line through
the eyelets of the housing.
_
Place the spool in the housing.
_
Place the lid onto the machine.
_
Make sure that the release buttons click
into place.
CAUTION! Under no circumstances wind extra line
on the empty spool but instead replace it with a new
one, the same as the original. The use of line with
different characteristics to those of the original can
permanently damage the grass trimmer as well as
annulling the terms of the guarantee.
ADJUSTING THE HEIGHT : 106~126cm
The telescopic tube can be adjusted in
stages to the desired length to achieve a
comfortable operating height.
_
Keep the lock-off knob depressed.
_
Set the required height.
_
Release the knob.
_
Check that the tube is locked.
ADJUSTING THE GUIDE HANDLE
The guide handle can be adjusted to achieve a
good balance.
_
Loosen the adjustment knob.
_
Set the handle to the desired position.
_
Carefully tighten the adjustment knob.
DESCRIPTION
Your grass trimmer has been designed for
trimming and edging grass.
1. Power cord
2. Main handle
3. ON / OFF
4. Switch Ignition Lock
5. Additional handle
6. Lock button on the handle
7. Housing & coil wire
8. Lock adjustment collar
9. Lock the telescopic lock
10. Top Tube
11. lower tube
12. Guide wheel
13. Motor housing
14. coil wire
15. Cover the coil
16. button on the reel
17. Protection
18. Cable hook
19. Screw
20. cutting angle adjustment knob
21. "fire-son» Knife
ASSEMBLING
Do not connect the machine
to the mains socket before it
is completely assembled.
The grass trimmer is supplied with some
components not assembled. To assemble these
proceed as follows:
Assembling the motor housing
Insert the motor housing into the handgrip, make
sure the cable between will not be damaged.
Mounting the guard
Align the reference indices of the body of the spool
holder and of the guard . Insert the guard in the
body (up to the collar) and rotate it in the direction
indicated by the arrow until the hole of the guard
corresponds to that of the body. Firm the screws
supplied.
Caution! During this operation beware of the line
cutter blade. You may be wounded.
Caution! Never use the grass trimmer without the
guard. It is vital for your and other peoples' safety
and for the good working order of the trimmer. The
failure to observe this safety regulation is not only
dangerous but also annuls the guarantee terms.
Use of the cable holder
The handle is equipped with a cable holder that
serves for connection of the extension cable.
25
Publicité
Table des Matières
