Cooper Lighting Solutions Lumiere 1004-A1-RCS-FL-LED2790-F-BK-L1-UNV-RSM Instructions D'installation page 3

PATHWAY AND SIGNS
1. Unpack and ensure all included parts are present.
2. Remove Trim Ring by turning counter-clockwise to
release.
3. Loosen 3x 8-32 nuts with an 11/32 nut driver or wrench.
4. Twist Universal Mount Plate to release from fixture
assembly.
5. Attach Universal Mount Plate to existing junction box
with proper hardware (not included). Route building
AC supply wires and ground wire out of center hole in
Universal Mount Plate.
6. Connect building AC supply wires from junction box to
input wires on fixture enclosure. See wiring table for
reference.
7 . Secure the Fixture Assembly to the Universal mount
plate and gasket with the 3x 8-32 nuts. Tighten nuts
using a 11/32 nut driver or wrench. Ensure adequate
gasket compression to provide proper seal from the
environment.
8. Attach Trim Ring by turning clockwise to secure.
9. Using a 3/32" Allen Wrench, slightly loosen the set
screw at knuckle base for rotational adjustment. Using
a 9/64" Allen Wrench, slightly loosen the screw at
the knuckle joint for angle adjustment. Once properly
positioned, ensure both screws are secured..
Figure 4.
Installation Instructions - Lanterra - RSM (Round Surface Mount)
Fixture Assembly
Knuckle
Trim Ring
8-32 Nuts
Universal Mounting
Plate
Junction Box(Provided
By Others)
Figure 5.
SIGNS (ADDITIONAL VIEWS)
Figure 6. 1000-SU1-RSM VERSION
COOPER LIGHTING SOLUTIONS
Knuckle Joint Screw
Fixture Assembly
Set Screw
Mount Plate And Gasket
IL509003EN Installation instructions
3