Cooper Lighting Solutions Lumiere 1004-A1-RCS-FL-LED2790-F-BK-L1-UNV-RSM Instructions D'installation page 2

Installation Instructions - Lanterra - RSM (Round Surface Mount)
INSTALLATION
ACCENTS
1. Unpack and ensure all included parts are present.
2. Remove Trim Ring by turning counter-clockwise to
release.
3. Loosen 3x 8-32 nuts with an 11/32 nut driver or wrench.
4. Twist Universal Mount Plate to release from fixture
assembly.
5. Attach Universal Mount Plate to existing junction box
with proper hardware (not included). Route building
AC supply wires and ground wire out of center hole in
Universal Mount Plate.
6. Connect building AC supply wires from junction box to
input wires on fixture enclosure. See wiring table for
reference.
7 . Secure the Fixture Assembly to the Universal mount
plate and gasket with the 3x 8-32 nuts. Tighten nuts
using a 11/32 nut driver or wrench. Ensure adequate
gasket compression to provide proper seal from the
environment.
8. Attach Trim Ring by turning clockwise to secure.
9. Using a 3/32" Allen Wrench, slightly loosen the set
screw at knuckle base for rotational adjustment. Using
a 9/64" Allen Wrench, slightly loosen the screw at
the knuckle joint for angle adjustment. Once properly
positioned, ensure both screws are secured.
8-32 Nuts
GN
WH
BK
PU
GR
Universal
Mounting Plate
Fixture Assembly
Figure 1.
2
COOPER LIGHTING SOLUTIONS IL509003EN
Knuckle
Trim Ring
Installation instructions
Mount Plate
Fixture Assembly
and Gasket
Figure 2.
Figure 3 . 1000-A2-RSM VERSION
Set Screw
Knuckle