PULOX PO-200 Mode D'emploi page 25

9. Troubleshooting
Trouble
The SpO2 and Pulse
Rate can not be
displayed normally
The SpO2 and Pulse
Rate are not
displayed stably
The device can not be
turned on
The display is off
suddenly
10. Key of Symbols
Symbol
Possible Reason
1. The finger is not
properly positioned
2. The patient's SpO2
is too low to be
detected.
1. The finger is not
placed inside deep
enough.
2. The finger is
shaking or the patient
is moving.
1. The batteries are
drained or almost
drained.
2. The batteries are
not inserted properly.
3. The malfunction of
the device
1. The device will
power off
automatically when it
gets no signal within
5 seconds.
2. The battery is
almost drained away.
Description
Type BF applied
part
Solution
1. Place the finger
properly and try
again.
2. Try again; Go to a
hospital for a
diagnosis if you are
sure the device works
all right.
1. Place the finger
properly and try
again.
2. Let the patient
keep calm
1.Change batteries
2. Reinstall batteries.
3. Please contact the
local service center.
1. Normal.
2.Change batteries
Symbol
WEEE
(2002/96/EC)
EN
Description