PULOX PO-200 Mode D'emploi page 24

3) Let the patient's finger put into the rubber cushions of the clip (make
sure the finger is in the right position), and then clip the finger.
4) Press the switch button once on front panel.
5) Do not shake the finger and keep the patient at ease during the process.
Meanwhile, human body is not recommended in movement status.
6) Get the information directly from screen display.
7) The device could change display direction according to the handing
direction.
Fingernails and the luminescent tube should be on the same side.
8. Cleaning, Transportation and Storage
 Please change the batteries when the low-voltage displayed on the
screen.
 Please clean the surface of the device before using. Wipe the device with
medical alcohol first, and then let it dry in air or clean it by dry clean
fabric.
 Using the medical alcohol to disinfect the product after use, prevent
from cross infection for next time use.
 Please take out the batteries if the oximeter is not in use for a long time.
 The best storage environment of the device is -40ºC to 60ºC ambient
temperature and not higher than 95% relative humidity.
High-pressure sterilization cannot be used on the device.
Do not immerse the device in liquid.
It is recommended that the device should be kept in a dry
environment. Humidity may reduce the useful life of the device, or
even damage it.
Figure 5 Finger Position
EN