Publicité
Removing the chuck.
1 Open jaws of chuck as wide as they go by turning chuck
sleeve (A) anticlockwise (when viewed from above).
2 Carefully tap chuck with mallet (B) in one hand while
holding chuck in other hand to prevent dropping it
when released from spindle nose.
Depth stop, Fig 10.2 (only for td 16t and td 16s)
The depth stop enables the drilling of holes in the work-
piece until a defined depth. Adjust the ring (6) usiing the
scale to the desired depth and tighten the ring with the
wing nut (7).
Depth stop, Fig. 13 (only for td 13t)
The depth stop enables the drilling of holes in the work-
piece until a defined depth. You have two options for
that.
Drilling to a specific depth.
1 Mark the drilling depth (H) on one side of the work-
piece.
2 WITH THE SWITCH „OFF", bring the drill bit down
until the tip or lips are even th the mark.
3 Hold the feed handle at this position.
4 Spin the lower nut {B) down to contact the depth stop
lug {C) on the head.
5 Spin the upper nut {D) down and tighten against the
lower nut.
6 The chuck and the drill bit wiII now be stopped after
traveling downward the distance selected on the depth
scale.
Depth scale method
Note: for this method, with the spindle in its upper posi-
tion the tip of the drill bit must be just slightly above the
top of the workpiece
1 Switch off the machine, lower the drill so far until the
indicator (E) points at the desired drilling depth of the
depth scale (F).
2 Turn the lower nut (B) downwards until it reaches the
lower stop (C).
3 Lock the lower nut (D) against the upper nut.
4 The chuck and the drill bit will now be stopped after
traveling downward the distance selected on the depth
scale.
Positioning table and workpiece, Fig. 14
Always place a piece of back up material (A) ('wood, ply-
wooood...) on the table undemeath the workpiece (B).
This wiII prevent splitering or making a heavy burr on
the underside of the workpieces as the drill bit breaks
through. To keep the back up material from spinning out
of control it must contact the left side of the column as
illustrated.
Warning: to prevent the work piece or the backup mate-
rial from being torn from your hand whiile drilling, posi-
tion them to the left side of the column. If the work piece
BA td 13-16.indd 33
All manuals and user guides at all-guides.com
33
15.04.11 10:58
Publicité
