Publicité
Machine head and pillar, Fig. 6
1 Place the machine head (4) onto the pillar (2).
2 Put the spindle of the drilling machine with the table
and the base plate in the cover and fasten the 2 Allen
screws (c).
Drill chuck protection with depth stop, Fig. 7.1 (only td 13t )
Fit the chuck protection with depth stop (11) onto the
spindle pipe and tighten the slotted screw (d).
Caution! The depth stop must be fed through the drilling
(17) on the housing. Screw on the two nuts (e) and place
the indicator (g) onto the depth stop. The indicator (g)
must point at the scale.
Drill chuck protection, Fig. 7.2
(only td 16t and td 16s)
Fit the chuck protection (10) onto the spindle pipe and
fasten the slotted screw (d).
BA td 13-16.indd 25
All manuals and user guides at all-guides.com
25
15.04.11 10:58
Publicité
