Bosch SHE44C Guide D'entretien Et D'utilisation page 13

Adding Detergent and Rinse Agent
Opening the Detergent Dispenser
Cover
NOTE : To open the detergent dispenser
cover, press the blue release in the direction
shown in Figure 22. Pressing down on the
release tab will not open the cover.
Press
the blue
release
tab in
the
direction
shown
by the
arrow in
Figure
22.
The cover will slide open to the right.
Filling the Rinse Agent Dispenser
Open the rinse agent dispenser by pressing the
star on the cover with your index finger while
lifting the tab with your thumb as shown in Figure
23.
Figure 23
Add liquid rinse agent to the dispenser as shown
in Figure 24A until the rinse agent reservoir is full.
Wipe up any excess rinse agent that puddles
when the dispenser reservoir is full.
Figure 24
Figure 22
B
(continued)
Return the rinse agent dispenser cover to its shut
position and press it firmly so that the cover
snaps shut.
NOTE : Figure 24B represents a completely
empty rinse agent reservoir.
Refill the rinse agent dispenser when the rinse
agent reservoir level indicator as shown in Figure
24B begins to show a silver background with
black lines or when the Refill Rinse Agent
indicator comes on.
NOTE : After filling the rinse agent dispenser, the
Refill Rinse Agent Indicator will go out in a few
minutes after the dishwasher door is shut.
Rinse Agent Dispenser Regulator
The amount of rinse agent dispensed can be
regulated to control spotting and streaking. The
Rinse Agent Dispenser Regulator as shown in
Figure 25 leaves our factory set at 4.
Figure 25
To adjust the amount of rinse agent
dispensed:
1. Open the rinse agent dispenser cover.
2. If your dishes are streaked after washing,
turn the regulator to a lower number.
3. If your dishes are spotted after washing,
turn the regulator to a higher number.
11