Sample Applications - Lehmannaudio Linear SE Mode D'emploi

50 Linear SE

Sample applications

EN
1 | SACD player and one headphone
In this sample configuration the Linear SE is used as a headphone amp with an
SACD player.
After connecting the Linear SE to the mains grid connect the SACD player to the
line input located on the rear panel of the device by means of an RCA cable.
The headphone is then connected on the front panel of the device.
Finally set the gain on the bottom side of the device for the headphone you're
using (see p. 48/49).
2 | Media player, active loudspeakers
In this sample configuration the Linear SE is used as a preamp för active loud-
speakers in combination with a media player.
After connecting the Linear SE to the mains grid connect the media player to
the line input located on the rear panel of the device by means of an RCA cable.
Now connect the active speakers to the line output of the Linear SE by using an
RCA cable.
Finally set the gain on the bottom side of the device to +0 dB (see p. 48/49).
Linear SE 51
EN