Publicité
Les langues disponibles
Les langues disponibles
4
10
9
8
9
4.Use M8 x 80 screw (10), 8mm ID washer (9), and M8
nut (8) to attach handle to foot stand. Tighten.
5
5.Use 50 x 10 rubber pad, 10mm ID washer and konb to
attach heater to foot stand. Tighten knobs.
Salamander Heater
10
9
9
8
6.Connect the electrical power supply cable to the wiring
compartment. (See wiring instructions).
Attach connectors to the appropriate conductor and ground
wiring. After completing the connections, arrange pigtail
unit leads and power supply wires in wiring compartment.
Wall Mount Installation Instructions:
1. Keep unit at least 6 feet (1.8 m) away from floor. Minimum
distance must be maintained.
2. Do not install closer than 4 feet (or 1.2 m) to any adjacent
vertical surfaces or walls.
3. Keep at least 4.5 inches (11.5 cm) from back wall (with or
without wall hanging mounting bracket).
4. Mark drill-hole positions in wall or ceiling for mounting
bracket.
5. Drill holes for required diameter fit (anchor provided) to
ensure correct position for mounting bracket.
6. Insert anchors.
7. Confirm mounting bracket is securely
attached to wall or ceiling with screws.
8. Attach bracket to heater housing with knobs and
rubber pads. Insert lock pin.
9. Mount heater assembly onto mounting bracket and
align holes. Insert hex bolt and tighten with nut. Install lock
pin.
6
Assembly Instructions
Publicité
