Publicité
Les langues disponibles
Les langues disponibles
Installing the clamping jaw (Fig 3)
1.
Depress the end of unlock Button with one hand, Use the other hand to tilt the saw head so that
the shoe of front guard can enter into the opening of the clamping jaw, at this moment keep two
inserts of the clamping jaw line up with corresponding slots on the front guard. Push it in, let it go
as far as possible.
2.
Release the Unlock Button to lock the clamping jaw. Check the clamping jaw be locked tightly or
not.
NOTE:
If the blade was assembled in the tool, to remove the clamping saw, it's better to remove the blade
firstly.
Removing the clamping jaw (Fig.4)
To remove the clamping jaw, Depress the end of Unlock Button with one hand, then Pull clamping jaw
out along the slot of the front guard, after the clamping jaw leave out the main housing completely,
Release the Unlock Button and it will go back to its original position.
ASSEMBLY
Fig.3
Depress
Insert
Clamping jaw has been assembled
Fig.4
Depress
Remove
Clamping clamp has been removed
45
Publicité
