Publicité
Les langues disponibles
Les langues disponibles
the cutting tool jams in the work piece.
6. When the cut is completed, switch off the machine
and then pull the saw blade out of the cut only after it
has come to a standstill. In this manner you can avoid
kickback and can place down the machine securely.
7. Use only undamaged saw blades that are in perfect
condition. Bent or dull saw blades can break, negatively
influence the cut, or lead to kickback.
8. Do not brake the saw blade to a stop by applying side
pressure after switching off. The saw blade can be
damaged, break or cause kickback.
9. Clamp material well. Do not support the work piece with
your hand or foot. Do not touch objects or the floor with
the saw running. Danger of kickback.
10.Secure the work piece. A work piece clamped with
clamping devices or in a vice is held more secure than by
hand.
11.Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
12.Before any work on the machine (e. g. maintenance,
changing the tool, etc.) as well as during its transport
and storage, lock the On/Off switch in the off position.
There is danger of injury when the On/Off switch is
unintentionally actuated.
13.Protect the power tool against heat, e. g., against
continuous intense sunlight, fire, water, and moisture.
Danger of explosion.
14.Wear the dust mask when using the tool .
44
Publicité
