Operating Notes - AKG Acoustics WMS40 microtools GB40 guitarbug Mode D'emploi

Fig. 3: Using the CU 40 optional charger.
To charge the battery, insert the trans-
mitter (1) into the optional CU 40 charger
(2) as shown in fig. 3.
For details, refer to the CU 40 charger
manual.
12

4 Operating Notes

4.1 Attaching the
Transmitter
Refer to fig. 4:
Fig. 4: Attaching the transmitter.
1. Swivel the jack plug (1) away from the
transmitter (2) to the stop.
2. Insert the jack plug (1) all the way into
the output jack (3) on your instru-
ment.
The spring inside the transmitter will
hold the transmitter securely in place
on the instrument. The soft plastic
pad on the bottom of the transmitter
will leave no trace on the instrument
surface.
4.2 Setting Levels (Refer to fig. 1)
1. Check that the receiver is marked
with the same color code as the
transmitter.
2. Use a small screwdriver to turn the
input gain control (4) on the transmit-
ter to a position halfway between the
left and right stops.
3. Set the ON/MUTE/OFF switch (1) to
ON to switch power to the transmitter
on.
4. Switch power to your sound system
or amplifier on.
5. Turn the volume control on your
instrument all the way CW and play a
few bars.