Télécharger Imprimer la page

Configure On Iphone / Ipad - PUSH VIDEO AVN801 Mode D'emploi

Publicité

Les langues disponibles

Les langues disponibles

1.3.2 Configure on iPhone / iPad

Before configuring this camera on iPhone / iPad, make sure:
You have installed our mobile program, EagleEyes-Lite or EagleEyes-Plus, on your iPhone or iPad. For
details, please refer to "APPENDIX 2 MOBILE SURVEILLANCE VIA EAGLEEYES" at page 20.
(Recommended) Your wireless router supports UPnP, and this function is enabled.
Note: If your wireless router doesn't support UPnP, you need to additionally access your router for port
forwarding. For details, please refer to "APPENDIX 4 CONFIGURE PORT FORWARDING" at page
23.
Your camera is connected to your wireless router with a RJ45 network cable, and it's powered on.
Note: Check
(LAN) status indicator is always on, not blinking. If it's blinking, check your RJ45
network cable and ensure it's not disconnected or defect.
You have checked the IP address used by your wireless router with the camera connected as instructed
below, and written it down. You'll need it later.
Connect your iPhone / iPad to the wireless router with the camera connected, and go to "Settings"
Select ">" near the selected wireless network to enter the details.
The IP address shown in "Router" is the IP address used by your wireless router. In the following example,
the IP address of your router is 192.168.2.1.
Note: This address will be needed when you want to access your router for port forwarding later.
Step1: Connect your iPhone to the wireless router which has the camera connected.
Step2: Open "EagleEyes" on your iPhone or iPad.
In the address book, click "+" to add new device. Then, select "Local Network Search" to search your
network camera. You'll see an IP address assigned by your router.
Note: If you can't find the camera, make sure your LAN status indicator ( ) is always on, and search
again after 3 minutes.
If you connect two or more cameras to the wireless router, you'll see many cameras with different IP
addresses after searching. To know which camera you're configuring, you may identify each with its
unique MAC address.
8
"Wi-Fi".

Publicité

loading

Ce manuel est également adapté pour:

Avn701