PUSH VIDEO AVN801 Mode D'emploi page 10

Note: The MAC address can be found on the sticker at the rear panel of the camera.
Step3: Select the IP address you want to
configure to show the IP address setting
page.
Switch the tab from "DHCP" to "Static".
The default port number is 88. You may
change it to any value (such as 8080) if
the port number of 88 is blocked.
Then, note down the IP address and
port number you see here. You might
need them for port forwarding later.
Step4: Select "Apply" to confirm all your
changes. Then, wait till you see "Done"
or "Fail" in "Status".
Regardless which message you see,
proceed as instructed below:
For Done, you'll return to the new device
page.
For Fail, select "
You'll later be prompted to select "DDNS" or
"Local IP". Select "DDNS" and return to the
new device page.
" on the top right side.
9