Camera Network Configurations; Assemble & Install Camera; Understand How Your Laptop / Computer Connect To Internet - PUSH VIDEO AVN801 Mode D'emploi

1. CAMERA NETWORK CONFIGURATIONS

Please follow the instructions below to finish camera installation and network configurations.
You may configure the network connection of this network camera with your laptop / computer, or with your iPhone®
or iPad® based on your network environment.
1.1 Assemble & Install Camera
Step1: Fasten the base of the bracket (the round one) to where the camera is installed.
Note: The distance between your camera and the location you want to monitor should be 3 ~ 4 meters,
for the built-in human detection function to work properly.
Step2: Assemble the bracket and the camera, and adjust the viewing angle of the camera.
Step3: Connect the supplied power adapter to the camera's power jack (DC 5V / 2A) on the rear panel and the power
outlet.
Step4: Continue to proceed network configurations as instructed in the following sections.

1.2 Understand How Your Laptop / Computer Connect to Internet

Then, connect your network camera directly to your wireless router / router / hub / modem with a network cable,
and power it on.
5