Model Calibration; Landing; Maintenance - XciteRC Rocket 55XXS Mode D'emploi

Model calibration

EN

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the Quadrocopter.
• NOTE: if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
22
Landing · Maintenance · Troubleshooting
The model flies no longer stable, e.g. after a serious crash, it may
be necessary to calibrate it again. Proceed as follows:
Turn the model on as usual, then move throttle lever once all the
way up and back down to bind the model.
Set the skill level to 100% (press skill level button 2 times)
Move and hold both control levers in the lower left corner . After a
few seconds the models LED's will start flashing to indicate that
the calibration has been successfully completed.
XciteRC Rocket 55XXS