Safety Instructions - Zibro A2W300 Manuel D'utilisation Et D'installation

A

SAfETy INSTRUCTIONS

G
•
•
•
•
•
•
•
•
4
32
• Please read this manual completely before installing the product.
• The heat pump boiler has no water purification function. Therefore
the water supplied to the heat pump boiler must be normal drinkable
tap water. Otherwise dangerous situations might occur and/or the
lifetime expectation of the product might be significantly reduced.
• The electricity supply to the device must be checked by a recognized
professional if you have any doubts regarding the compatibility.
• Install this device only when it complies with local/national legislation,
ordinances and standards. This product is intended to be used as a
heat pump boiler in indoor residential houses and is only suitable for
use in dry locations, in normal household conditions and must only be
used to heat normal sanitary tap water.
Check the mains voltage and frequency. This unit is only suitable for
earthed sockets, connection voltage 230 V~ / 50 Hz.
This equipment must be earthed and installed with a ground fault
switch. It can possibly cause electrical shock, injury and property damage
if grounding is not perfect.
• Zibro recommends that the heat pump boiler is inspected and serviced
by an authorized dealer or installer every year: lifespan of the heat
pump boiler will be longer, the likelihood of errors will be reduced
and the capacity remains high.
• The heat pump boiler is very heavy (100 kg). Use sufficient man power
(≥ 4 persons).
The accurate specifications are presented on the rating label on the unit.
Installation work must be performed in accordance with all European, national
and / or local directives and standards, and repairs must be done by authorized
personnel only. The guarantee is invalid for damage caused by neglect or by
actions that deviate from those in this instruction booklet.
When installing or providing maintenance always make sure to wear the correct
personal safety protections such as protective eyewear, gloves, mouth caps, ear
protection etc.
Perform electrical work according to the manual and be sure to use an exclusive
electrical circuit. If the capacity of the power circuit is insufficient it could result in a
fire or an electric shock.
This device is manufactured according to CE safety standards. Nevertheless, you
must take care, as with any other electrical device.
The plug on the cable of the device must fit into the wall socket.
Always remove the plug of the heat pump boiler from the wall socket when the
heat pump boiler is not in use.
A damaged power cord or plug must always be replaced by a recognized