Publicité
Les langues disponibles
Les langues disponibles
8059833
Problem(s)
The spray pattern
is arched.
The spray pattern
is uneven.
The center of the pattern
is too narrow.
There is poor
atomization with the
spray concentrated in
the center.
Visit www.princessauto.com for more information
HVLP Gravity Feed Spray Gun
Possible cause(s)
Material residue in the holes is
obstructing the passage of material
The nozzle is dirty
or malfunctioning.
The atomization cap is dirty
or damaged.
Fluid Nozzle loose or worn.
Material has built up on the outside
of the fluid nozzle tip or center hole
or partially clogged the
nozzle orifice.
The fluid nozzle is loose.
The atomization of the air pressure
is too high.
The working material is too thin.
The flow of paint is greater than
the pressure and quantity of
air supplied.
Suggested solution(s)
Submerge the head in solvent.
Clean and open all closed holes with a
jet of compressed air or a toothpick.
Do not use pointed metal objects for
this purpose, as you may deform the
hole at the end of the head.
Tighten the nozzle using the
wrench provided.
Replace nozzle.
Clean the head and the nozzle.
Ensure that the centering between the
head and nozzle is precise.
Check that the tip of the pin
is not ruined.
Replace the head and nozzle
if necessary.
Reduce the quantity of air and
increase the paint viscosity.
Clean the head and the nozzle.
Ensure that the paint is not too dense
and dilute if necessary.
V 2.9
7
Publicité
