Viewing Flopro-Md Data - Watts Dormont FloPro-MD Manuel D'installation Et D'utilisation

Viewing FloPro
Use the tabs in the gray header to change the amount of
time visible in the chart from one to 12 hours .
• Now displays real-time readings .
• Data continues to load from the most recently taken
sample to the oldest as long as the app is connected to
the device .
• Data is displayed graphically and the real-time data
point is also displayed in the lower left corner .
• There are several data modes that can be selected from
the MODE drop down menu .
o Flow – gas flow in cubic feet per hour (CFH)
o BTU – gas capacity in BTU per hour (BTU/hr)
o Pressure – gas pressure in inches of water column (in/H
o Temperature – device temperature inside the housing in degrees Fahrenheit (°F)
• The FloPro-MD application displays the average, minimum and maximum data readings
based on the sample rate set on the FloPro-MD . The data rate can be customized . Refer
to the previous section for instructions .
• Use the < and > buttons below the graph to move backward and forward in time .
10
-MD Data
™
O)
2