Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
7.2 When using the other features of the
Reanimator, always observe the following
EN
steps:
1. Ensure the battery clamps are securely
clipped in the storage holders.
2. Charge the Reanimator as soon as possi-
ble after using the feature.
7.3 Powering a 12V DC Device:
The Reanimator is a power source for all 12V
DC accessories that are equipped with a 12V
accessory plug. Use it for power outages
and fishing or camping trips. Make sure the
device to be powered is OFF before inserting
the 12V DC accessory plug into the 12V DC
accessory outlet.
1. Open the protective cover of the DC power
outlet on the front of the Reanimator.
2. Plug the device into the outlet and turn the
device on (if required).
3. If the device draws more than 15A or has
a short circuit, the internal circuit breaker
of the Reanimator will trip and disconnect
the power to the device. Disconnect the
device and the breaker will automatically
reset.
The DC power outlet is wired directly to the
internal battery. Extended operation of a 12V
device may result in excessive battery drain.
Recharge immediately after unplugging the
device.
www.herthundbuss.com
8. Fuse replacement
The Portable Power is equipped with an inline
fuse, to protect the battery from overload.
Technical data, fuse:
Reanimator 4400:
Reanimator 1900:
WARNING
Keep away from sparks and flame –
battery could emit explosive gases.
1. Allow the fuse to cool down completely
(approximately 5 minutes).
2. Make sure the switch is in the OFF (0) po-
sition and the unit is unplugged from the
external charger.
3. Remove the positive (RED) clamp from the
storage compartment on the side of the
unit and locate the fuse holder.
4. Open the fuse holder by removing its
cover.
95980701 | -702
Fast blow,
DC automotive type,
rated 32 V, 500
A (Buss AMG-500)
Fast blow,
DC automotive type,
rated 32 V,
300 A (Buss AMG-300)
28
Publicité
