Tonfly XP S 72-600 Manuel D'utilisation page 4

HELMET COMPONENTS FOR VISOR REPLACEMENT
3.0 mm
HELMET CARE AND MAINTENANCE
High temperatures, such as those typically found in a car exposed to direct sunlight, may
deteriorate the helmet's condition over time.
Any changes made to the helmet, in particular any application of paints, adhesives or any use of
detergents, chemicals or solvents, may damage the helmet and reduce the level of protection.
Clean your helmet with water, mild soap and using a soft and clean cloth.
Products based on solvents, hydrocarbons or acids shouldn't be used under any circumstances.
Before storing your helmet for extended time, it is necessary to clean it thoroughly.
Keep the helmet away from any source of heat or direct light, in its original packaging and at
temperatures between -10° C and +40° C.
When traveling, it is recommended that you protect your helmet using the original protective
pouch and that you put the helmet into the original box.
Any strike or impact may damage the helmet even if it does not show any clear signs of damage.
A damaged helmet comes with a reduced capacity to protect you from future impacts.
For this reason, if you suspect any helmet of being damaged, you must replace it.
Even a well-maintained helmet deteriorates over time and can no longer guarantee adequate
protection, despite appearing to be in a good shape. It is therefore recommended to have it
replaced after 3 years of use. Any cracks, loosening parts, deformations, chipping or colour
changes represent substantial reasons to have the wear and tear of your helmet checked.
Helmets for children should be replaced when they no longer fit.
4
DX SX
3.0 mm