Tonfly XP S 72-600 Manuel D'utilisation page 2

WARNINGS
Please read the instruction manual carefully.
Ignoring these instructions may reduce the protection which your helmet is designed to provide.
The helmet's level of protection is only ensured if it includes all of its original components.
Thus, any modification of the product or the removal of one of the original components will
cause non-conformity of the delivered material.
• Never fly without a helmet
Life is too important to risk losing it due to a senseless omission.
• Ensure that the helmet you are using has
• TFX helmet was manufactured in accordance with specific strict regulations:
XP S72-600 Standard 10.2016
EN966: 2012+a1: 2012
• Never trust a helmet without any
• We always recommend flying with a full-face helmet
A full-face helmet provides the best possible protection.
• Never modify your helmet for any reason
• Handle your helmet and visor with great care.
• Never allow your helmet to fall to the ground
• Always make sure that the helmet's chin strap is properly fastened
• In case of an accident, even if it is just a minor impact and there is no visible damage,
the helmet must be replaced.
TFX
helmet was approved in accordance with
This helmet meets the basic health and safety requirements.
This standard concentrates on Skydiving and Windtunnel properties, which includes
shock protection, reduction of defects and the ability to remove the helmet under stress.
TFX helmet was also approved in accordance with
Regulation (EU)2016/425. The helmets are tested and checked in accordance with this standard.
They offer shock-absorbing capacity, resistance to penetration by sharp objects, resistance to
detachment at impact, resistance in the chin area.
Declaration of Conformity: https:/ /www.tonfly.com/docs/TFX_Declaration_of_Conformity.pdf
2
EN 966 or XP S72-600
EN 966 or XP S72-600
XP S 72-600
EN 966:2012+A1:2012
certifications
certification label
Standard for Skydiving and Windtunnel
standard by the