RDI AVALON Instructions Pour L'installation page 5

4.
Measure the length of the beams and cut
the top rail (sold separately) to same length.
This should match the cuts in Step 1. Press
top rail end covers onto the top rail and set
in place on top of the top beam (Fig. 10).
Press down on the top rail to ensure that it
fits snugly onto the top beam and ensure that
top rail end covers are being held in place by
the mounting bracket.
5.
Using the holes in the bracket as a guide,
pre-drill two / " holes from under the bottom
1
8
of the rail up through the top rail as shown in
Figure 11. Drive two 1
the hole locking the bracket, panel, and top
rail together, being careful not to drill through
the top of the top rail (circled with dotted line).
Fig. 10
6.
Install the glass slats by adding a drop of the
silicone caulk into the middle of the bottom
glass gasket (Fig. 12). Slide the top glass
/ " screws up through gaskets (component E) over one end of the
5
8
glass slat as shown in figure 13, and at a
slight angle, place the top of the glass slat
up into the top beam, sliding it up enough
to allow the bottom of the glass slat to drop
down into the bottom glass gasket. Slide the
top glass gasket up to fit snugly into the top
beam (Fig. 14). Repeat for remaining glass
slats.
Install pyramid post top onto each post.
Note: A rubber mallet may be needed for
proper fit.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
5