RDI AVALON Instructions Pour L'installation page 4

LEVEL RAIL
1.
Place the bottom beam across the opening
and adjust to ensure equal baluster spacing
on each end (Fig. 1). Mark the rail panel
at the post face at both ends of the beam
shown in Figure 1. Measure ¼" from the
marks towards the center of the bottom
beam (to allow for bracket clearance, Fig.
2) and cut both the top and bottom beams
at both ends using a carbide tip blade of at
least 60 teeth.
Ensure support channel is inside bottom
beam (Fig. 3) before cutting; channel is
required to distribute the load of the glass
slats along the rail.
2
1
4
2.
Open the paper bracket mounting template
(included with brackets), align base trim
with appropriate guide on template, and
secure template in place using a piece of
tape. Pre-drill through the desired marked
locations on the template using a
Remove template, align brackets (Fig. 4) with
the holes ensuring that brackets are square,
and fasten brackets in place using the 1 ½"
screws provided.
Press bottom bracket covers onto the ends
of the bottom beam (Fig. 5) and set onto
bottom brackets, pressing in place. Place top
beam in place on top brackets (Fig. 6).
Fig. 1
Top Level Bracket
3 4
Fig. 2
Fig. 3
3.
Pivot support foot in place under the rail as
shown (Fig. 7). (Note: If using a section longer
than six feet, use two support feet (included
with 8' panels) and distribute evenly along
length of panel). Secure support foot/feet to
/ " drill bit. the mounting surface using the 1 ½" screw(s)
1
8
provided and press fit cover into place using
plastic plug(s) as shown (Fig. 8 & 9).
Fig. 4
Bottom Level Bracket
Fig. 5
Fig. 6
Fig. 7
Fig. 8
A.
B.
Fig. 9